黄金眼
发表于 2013-10-15 09:38:53
本帖最后由 黄金眼 于 2013-10-31 09:38 编辑
citydeer 发表于 2013-10-14 13:07 static/image/common/back.gif
楼主有没有AB对比过MAC?mac mini ssd+audirvana plus direct模式感觉很惊艳。
听过采用的mac系统加JR MAC版本。
akycn
发表于 2013-11-5 17:42:26
这个牛逼了一齐来顶起吧!
xxx3212
发表于 2013-11-9 19:55:08
{:soso_e100:}
hcbo
发表于 2013-11-19 14:06:23
机箱不错,能否PM一下那里做的.谢谢.
黄金眼
发表于 2013-12-8 19:07:31
hcbo 发表于 2013-11-19 14:06 static/image/common/back.gif
机箱不错,能否PM一下那里做的.谢谢.
自己做的
忽忽
发表于 2013-12-9 17:39:46
挺有营养的帖子呀,请问LZ怎么设置能让系统的声音都是Jriver处理出来的?
黄金眼
发表于 2013-12-9 18:41:17
忽忽 发表于 2013-12-9 17:39 static/image/common/back.gif
挺有营养的帖子呀,请问LZ怎么设置能让系统的声音都是Jriver处理出来的?
载入实时音频
lanhai20058
发表于 2013-12-9 19:05:32
很强大!
Phase
发表于 2013-12-11 17:28:14
________________________________________________________________________
CPU SPEED
_________________________________________________________________________________________________________
Reported CPU speed: 2093.0 MHz
Measured CPU speed: 1363.0 MHz (approx.)
Note: reported execution times may be calculated based on a fixed reported CPU speed. Disable variable speed settings like Intel Speed Step and AMD Cool N Quiet in the BIOS setup for more accurate results.
_________________________________________________________________________________________________________
MEASURED INTERRUPT TO USER PROCESS LATENCIES
_________________________________________________________________________________________________________
The interrupt to process latency reflects the measured interval that a usermode process needed to respond to a hardware request from the moment the interrupt service routine started execution. This includes the scheduling and execution of a DPC routine, the signaling of an event and the waking up of a usermode thread from an idle wait state in response to that event.
Highest measured interrupt to process latency (μs): 363.966709
Average measured interrupt to process latency (μs): 6.943257
Highest measured interrupt to DPC latency (μs): 358.585481
Average measured interrupt to DPC latency (μs): 1.908440
_________________________________________________________________________________________________________
REPORTED ISRs
_________________________________________________________________________________________________________
Interrupt service routines are routines installed by the OS and device drivers that execute in response to a hardware interrupt signal.
Highest ISR routine execution time (μs): 26.935022
Driver with highest ISR routine execution time: storport.sys - Microsoft Storage Port Driver, Microsoft Corporation
Highest reported total ISR routine time (%): 0.004607
Driver with highest ISR total time: storport.sys - Microsoft Storage Port Driver, Microsoft Corporation
Total time spent in ISRs (%) 0.005316
ISR count (execution time <250 μs): 1166
ISR count (execution time 250-500 μs): 0
ISR count (execution time 500-999 μs): 0
ISR count (execution time 1000-1999 μs): 0
ISR count (execution time 2000-3999 μs): 0
ISR count (execution time >=4000 μs): 0
_________________________________________________________________________________________________________
REPORTED DPCs
_________________________________________________________________________________________________________
DPC routines are part of the interrupt servicing dispatch mechanism and disable the possibility for a process to utilize the CPU while it is interrupted until the DPC has finished execution.
Highest DPC routine execution time (μs): 78.511706
Driver with highest DPC routine execution time: igdkmd64.sys - Intel Graphics Kernel Mode Driver, Intel Corporation
Highest reported total DPC routine time (%): 0.08080
Driver with highest DPC total execution time: rspLLL64.sys - Resplendence Latency Monitoring and Auxiliary Kernel Library, Resplendence Software Projects Sp.
Total time spent in DPCs (%) 0.111713
DPC count (execution time <250 μs): 162608
DPC count (execution time 250-500 μs): 0
DPC count (execution time 500-999 μs): 0
DPC count (execution time 1000-1999 μs): 0
DPC count (execution time 2000-3999 μs): 0
DPC count (execution time >=4000 μs): 0
_________________________________________________________________________________________________________
REPORTED HARD PAGEFAULTS
_________________________________________________________________________________________________________
Hard pagefaults are events that get triggered by making use of virtual memory that is not resident in RAM but backed by a memory mapped file on disk. The process of resolving the hard pagefault requires reading in the memory from disk while the process is interrupted and blocked from execution.
Process with highest pagefault count: none
Total number of hard pagefaults 0
Hard pagefault count of hardest hit process: 0
Highest hard pagefault resolution time (μs): 0.0
Total time spent in hard pagefaults (%): 0.0
Number of processes hit: 0
_________________________________________________________________________________________________________
PER CPU DATA
_________________________________________________________________________________________________________
CPU 0 Interrupt cycle time (s): 0.820558
CPU 0 ISR highest execution time (μs): 26.935022
CPU 0 ISR total execution time (s): 0.012989
CPU 0 ISR count: 1166
CPU 0 DPC highest execution time (μs): 78.511706
CPU 0 DPC total execution time (s): 0.247343
CPU 0 DPC count: 157808
_________________________________________________________________________________________________________
CPU 1 Interrupt cycle time (s): 0.213859
CPU 1 ISR highest execution time (μs): 0.0
CPU 1 ISR total execution time (s): 0.0
CPU 1 ISR count: 0
CPU 1 DPC highest execution time (μs): 33.511706
CPU 1 DPC total execution time (s): 0.003560
CPU 1 DPC count: 863
_________________________________________________________________________________________________________
CPU 2 Interrupt cycle time (s): 0.203165
CPU 2 ISR highest execution time (μs): 0.0
CPU 2 ISR total execution time (s): 0.0
CPU 2 ISR count: 0
CPU 2 DPC highest execution time (μs): 26.698997
CPU 2 DPC total execution time (s): 0.011622
CPU 2 DPC count: 2362
_________________________________________________________________________________________________________
CPU 3 Interrupt cycle time (s): 0.254623
CPU 3 ISR highest execution time (μs): 0.0
CPU 3 ISR total execution time (s): 0.0
CPU 3 ISR count: 0
CPU 3 DPC highest execution time (μs): 37.159102
CPU 3 DPC total execution time (s): 0.010404
CPU 3 DPC count: 1575
_________________________________________________________________________________________________________
用latencymon测了下win8的数据,不知道怎么样....似乎波动挺大的?
Phase
发表于 2013-12-11 17:35:27
BIO关掉了CPU变频又测了一遍。。
_________________________________________________________________________________________________________
CPU SPEED
_________________________________________________________________________________________________________
Reported CPU speed: 2093.0 MHz
Measured CPU speed: 1380.0 MHz (approx.)
Note: reported execution times may be calculated based on a fixed reported CPU speed. Disable variable speed settings like Intel Speed Step and AMD Cool N Quiet in the BIOS setup for more accurate results.
_________________________________________________________________________________________________________
MEASURED INTERRUPT TO USER PROCESS LATENCIES
_________________________________________________________________________________________________________
The interrupt to process latency reflects the measured interval that a usermode process needed to respond to a hardware request from the moment the interrupt service routine started execution. This includes the scheduling and execution of a DPC routine, the signaling of an event and the waking up of a usermode thread from an idle wait state in response to that event.
Highest measured interrupt to process latency (μs): 32.287369
Average measured interrupt to process latency (μs): 3.286541
Highest measured interrupt to DPC latency (μs): 30.330559
Average measured interrupt to DPC latency (μs): 0.950583
_________________________________________________________________________________________________________
REPORTED ISRs
_________________________________________________________________________________________________________
Interrupt service routines are routines installed by the OS and device drivers that execute in response to a hardware interrupt signal.
Highest ISR routine execution time (μs): 14.465361
Driver with highest ISR routine execution time: storport.sys - Microsoft Storage Port Driver, Microsoft Corporation
Highest reported total ISR routine time (%): 0.013804
Driver with highest ISR total time: storport.sys - Microsoft Storage Port Driver, Microsoft Corporation
Total time spent in ISRs (%) 0.013848
ISR count (execution time <250 μs): 2357
ISR count (execution time 250-500 μs): 0
ISR count (execution time 500-999 μs): 0
ISR count (execution time 1000-1999 μs): 0
ISR count (execution time 2000-3999 μs): 0
ISR count (execution time >=4000 μs): 0
_________________________________________________________________________________________________________
REPORTED DPCs
_________________________________________________________________________________________________________
DPC routines are part of the interrupt servicing dispatch mechanism and disable the possibility for a process to utilize the CPU while it is interrupted until the DPC has finished execution.
Highest DPC routine execution time (μs): 30.197802
Driver with highest DPC routine execution time: storport.sys - Microsoft Storage Port Driver, Microsoft Corporation
Highest reported total DPC routine time (%): 0.006517
Driver with highest DPC total execution time: storport.sys - Microsoft Storage Port Driver, Microsoft Corporation
Total time spent in DPCs (%) 0.021341
DPC count (execution time <250 μs): 17696
DPC count (execution time 250-500 μs): 0
DPC count (execution time 500-999 μs): 0
DPC count (execution time 1000-1999 μs): 0
DPC count (execution time 2000-3999 μs): 0
DPC count (execution time >=4000 μs): 0
_________________________________________________________________________________________________________
REPORTED HARD PAGEFAULTS
_________________________________________________________________________________________________________
Hard pagefaults are events that get triggered by making use of virtual memory that is not resident in RAM but backed by a memory mapped file on disk. The process of resolving the hard pagefault requires reading in the memory from disk while the process is interrupted and blocked from execution.
NOTE: some processes were hit by hard pagefaults. If these were programs producing audio, they are likely to interrupt the audio stream resulting in dropouts, clicks and pops. Check the Processes tab to see which programs were hit.
Process with highest pagefault count: dgservice.exe
Total number of hard pagefaults 323
Hard pagefault count of hardest hit process: 253
Highest hard pagefault resolution time (μs): 18310.678930
Total time spent in hard pagefaults (%): 0.117899
Number of processes hit: 8
_________________________________________________________________________________________________________
PER CPU DATA
_________________________________________________________________________________________________________
CPU 0 Interrupt cycle time (s): 0.064762
CPU 0 ISR highest execution time (μs): 14.465361
CPU 0 ISR total execution time (s): 0.018332
CPU 0 ISR count: 2357
CPU 0 DPC highest execution time (μs): 30.197802
CPU 0 DPC total execution time (s): 0.023576
CPU 0 DPC count: 15253
_________________________________________________________________________________________________________
CPU 1 Interrupt cycle time (s): 0.008462
CPU 1 ISR highest execution time (μs): 0.0
CPU 1 ISR total execution time (s): 0.0
CPU 1 ISR count: 0
CPU 1 DPC highest execution time (μs): 6.402293
CPU 1 DPC total execution time (s): 0.000237
CPU 1 DPC count: 127
_________________________________________________________________________________________________________
CPU 2 Interrupt cycle time (s): 0.016151
CPU 2 ISR highest execution time (μs): 0.0
CPU 2 ISR total execution time (s): 0.0
CPU 2 ISR count: 0
CPU 2 DPC highest execution time (μs): 9.225036
CPU 2 DPC total execution time (s): 0.003194
CPU 2 DPC count: 1760
_________________________________________________________________________________________________________
CPU 3 Interrupt cycle time (s): 0.014330
CPU 3 ISR highest execution time (μs): 0.0
CPU 3 ISR total execution time (s): 0.0
CPU 3 ISR count: 0
CPU 3 DPC highest execution time (μs): 7.237458
CPU 3 DPC total execution time (s): 0.001242
CPU 3 DPC count: 556
_________________________________________________________________________________________________________
黄金眼
发表于 2013-12-11 17:45:41
Phase 发表于 2013-12-11 17:35 static/image/common/back.gif
BIO关掉了CPU变频又测了一遍。。
固定频率,关闭C3,C6等等功能,睿频也关闭了
0500
发表于 2013-12-11 17:50:06
人财物一流 顶
黄金眼
发表于 2013-12-16 17:20:08
0500 发表于 2013-12-11 17:50 static/image/common/back.gif
人财物一流 顶
照片里面器材都是烧友的
东方白
发表于 2013-12-17 12:35:07
好帖就该一顶再顶!{:soso_e179:}
chenxin5555
发表于 2013-12-17 22:19:27
楼主写的太牛了,佩服啊