|
|
发表于 2021-10-15 22:36:20
|
显示全部楼层
Thesycon driver for Windows
---------------------------
Audio Class 2.0 mode under MS Windows requieres a specific driver.
To use the USB interface in Audio Class 2.0 mode, please follow these step:
- Be sure to configure the board for Audio Class 2.0.
- Launch SETUP.EXE and follow the instructions.
- Click on ACCEPT when MS Windows warns you about unverified driver installation.
- Plug the USB cable according the installation wizard messages.
- Use MS WIndows control panel to set up the audio interface correctly.
- Configure your media player to use the USB Audio Asio driver.
Installing the driver on Windows 8 or 8.1
-----------------------------------------
To be able to install the version 1.56 driver on Windows 8 or 8.1 one has to disable the windows driver signing check. This can be done via a special windows booting option as follows:
1) If logged in as a user, log out. The log in screen appears. In the lower right corner the power on/off icon appears. Click on that icon, hold the Shift key and click on the "restart" selection.
2) Now a blue screen with some options appears, select trouble shooting at the bottom then select advanced options (or maybe extended options) at the bottom. Then select startup settings in the lower right then select restart. another screen appears which allows to select restart options. Press key 7 to select option 7) which deactivates the driver signature checking.
3) Now the windows starts again as usual, only that you can now install the USB driver w/o error message.
Proceed according to the instructions on top of this page.
Important notes:
----------------
- More information on system requirements can be found in TUSBAudio_UserManual.pdf
|
|
